Trampoline - Hobie TIGER Assembly Manual

1. Unfold the trampoline. Note that the trampoline has side tension lines that are already pre-threa-
ded. Insert the front edge of the trampoline into the track at the left, rear side of the front crossbar.
Continue feeding the trampoline into the track and position it in the center. line up the grommet in the
center of the trampoline with the dolphin striker post to ensure it is centered.
3. Move to the rear of the trampoline. Very closely to
where the side tensioning line exits the rear of the tram-
poline tie a loop. ensure you pull the side tensioning line
firmly as to tie the loop as closely to the trampoline where
the rope exits as possible. Tie a bowline or a similar loop
in the line which will be used for a 4:1 purchase of the
side tensioning lines. Repeat this step for the opposite
side rear corner.
4. Now take the tale of the side tensioning line and pass the rope through the pad-eye mounted on the
rear cross beam closest to where the line exits the trampoline. Then pass the line back through the
loop tied in step3. Again go through the pad-eye on the beam and back through the loop. This will pro-
vide a 4:1 purchase. Pull the line slightly as to take some tension for the sides but do not completely
tension at this stage. Repeat this step for the opposite side rear corner. Ensure that the trampoline is
still centered.
Trampoline assembly
2. Take one of the side tensioning lines and pass the line
through the pad-eye that is fixed to the front crossbar then
through the grommet of the trampoline near where the
rope exits the trampoline and back to the pad-eye. Then
fix it through the grommet that is near the crossbar using
a bowline knot.
Repeat this step at the opposite side front corner.