Siemens S7-1200 Operating Instructions Manual page 46

Configuration and operation
4.4 Configuration of the TeleService access
Global Security settings of the project
1. Open the following page in the project tree:
Global security settings > User management
2. Role
Open the "Roles" tab
The two tables "Roles" and "Rights of the role" become visible.
If necessary open the "Roles view" if this is hidden by the "Rights of the role" table.
In the "Roles" table (at the top) create a new user-defined role for TeleService.
3. In the "User" tab create a user that will later be allowed to execute the TeleService
functions for the CP.
Configure the following parameters:
– User name
– Authentication method
– Password
– Maximum time of the session
4. Click on the "Roles" tab.
5. Select the CP in the lower list "Rights of the role" under the "Module rights" group.
6. The available rights are displayed in the "List of rights" table.
The right "Use TeleService" is displayed.
7. Enable the "Use TeleService" right for the module.
8. Following this, set the S7 protocol to "allow" in Firewall.
46
Assign the name of the user that will have TeleService rights.
You require the user name at the start of a TeleService session.
Select the authentication method "Password" for this user.
Assign the password.
You require the password at the start of a TeleService session.
Note:
You specify the password properties of the security functions in the "Password
policies" tab.
You enter the password on the engineering station when starting a TeleService
session.
The time that can be configured here is only required for access to SCALANCE S
modules. If the user is set up only for TeleService sessions, you can leave the default
value unchanged.
Operating Instructions, 01/2015, C79000-G8976-C381-01
CP 1243-7 LTE