Table of Contents
Advertisement
3 Assembly
3.1 Base
The body of the fan needs to be fixed to its base.
To do this, first remove only the 4 screws as identified with the arrows in the diagram
below. NOTE: Do Not Remove any of the other screws.
Place the Base Ring over the base and push down firmly, then fasten with the 4
screws.
3.2 Safety Grille and Blade
Your Fan has been boxed unassembled to minimise packaging waste.
Each part is designed to fit together and be disassembled easily for cleaning or
storage.
To assemble the safety grille and blade assembly, take the motor assembly and place
the back safety grille into position ensuring the safety grille fits onto the locating lugs. If
this is done correctly, the safety grille's wire carry handle will be at the top on the back.
Fix the back safety grille into position by replacing the locking nut tightly by hand.
Do not over tighten the locking nut.
Rotate Clockwise to Tighten
Locating Lugs
Locking Nut
Page 6 of 9
Advertisement
Table of Contents
