3. Access Control
This page allows you to make access control to the AP or connected clients by offering the MAC Addresses
of the clients.
MAC Restrict Mode: Click Disabled to welcome all of the clients on the network; select Allow to
permit only the clients on the list to access the cable modem; or choose Deny to prevent the clients on
the list to access this device.
MAC Address: Your Gateway identifies wireless PCs by their Wireless MAC Address. This address
consists of a string of 6 pairs of numbers 0-9 and letters A-F, such as 00 90 4B F0 FF 50. It is usually
printed on the Wireless card of the device (e.g. the PCMCIA card in a laptop).
Enter the MAC addresses of the connected clients into the fields, and then click Apply to add them to
the list for access control.
Apply: After proper configuration, click Apply to invoke the settings.
Connected Clients: The information of currently connected clients will be displayed here.
Fig. 2-36 Gateway\Wireless\Access Control
Page 61 / 85