Panasonic CQ-VX2200W Operating Instructions Manual page 35

■
Cassette Tape
Trouble
High tones are improp-
erly emphasized.
Reproduction of high
tones is poor.
Wow and flutter is very
high.
■
Sound Setting
Trouble
No sound from left,
right, front, or rear
speaker
Left and right sounds
are reversed in stereo
listening.
Only bass or monaural
sound from rear speaker
■
Remote Control
Trouble
Buttons are invalid for
operation.
(continued)
Dolby B NR tape plays with Dolby B NR off.
aSet Dolby B NR to ON.
Metal type tape plays with normal mode.
aChange Normal mode to Metal mode.
Non-Dolby B NR tape plays with Dolby B NR on.
aSet Dolby B NR to OFF.
Normal type tape plays with Metal mode.
aChange Metal mode to Normal mode.
Heads are magnetized.
aDemagnetize heads. (Ask a service representative for advice.)
Tape running mechanism is dirty or out of order.
aClean tape running mechanism, or repair it. (Ask a service representative
for advice.)
Left and right balance, or front and rear balance is off on one side.
aAdjust BAL//FAD as appropriate.
Cables are not correctly connected.
aConnect the cables correctly.
The right speaker wire is connected to the left speaker and the left speaker wire
to the right speaker.
aConnect the speaker wires to the correct one.
SBC-SW is set to ON.
aSet SBC-SW to OFF.
Battery poles (+) (–) are reversed.
aInsert the battery correctly.
Wrong battery.
aCheck the battery.
Battery has run down.
aReplace the battery.
Remote control is in the wrong direction.
aDirect the remote control at sensor (REMOTE) on the panel.
Cause / Step
Cause / Step
Cause / Step
CQ-VX2200W
E
N
G
L
I
S
H
32 1
41