Panasonic CQ-VX2200W Operating Instructions Manual page 34

Troubleshooting
E
N
G
L
I
■
Radio
S
H
Trouble
31
Much noise in FM
stereo and monaural
broadcasts
Preset station is reset.
■
CD
Trouble
CD is in the CD com-
partment but no sound
is made, or CD is eject-
ed automatically.
CD sound skips, tone
quality is low.
Sound skip due to
vibration
CD is not ejected.
■
Cassette Tape
Trouble
No sound
Tape sound quality is
poor.
40
Station is too far, or signals are too weak.
aSelect other stations of higher signal level.
The radio antenna is not extended enough.
aExtend the radio antenna enough.
The motor antenna relay control lead is not connected correctly.
a If there is a motor antenna in the car, connect the motor antenna relay control
lead to the motor antenna lead that is installed in the car correctly.
Battery cable is not correctly connected.
aConnect the battery cable to the terminal that is always live.
CD is upside down.
aPlace CD in the correct direction with the label side up.
CD is dirty.
aClean CD, referring to the section on Notes on CD.
CD is dirty.
aClean CD, referring to the section on Notes on CD.
Mounting angle is over 30 degrees.
aAdjust mounting angle to less than 30 degrees.
Unstable mounting
aMount the unit securely with the mounting parts, referring to the section
on Installation.
¡CD is defective.
¡Mechanical trouble
aOpen the panel and press [u] (CD EJECT). If failure persists, press the
reset switch. If normal operation is not restored, call the store where you
purchased the unit or the nearest Panasonic Service Center to ask for
repairs.
Blank tape is inserted in the unit.
aInsert recorded tape into the unit.
Heads are dirty.
aClean Heads. (Ask a service representative for advice.)
Poor quality tape.
aUse better quality tape.
CQ-VX2200W
(continued)
Cause / Step
Cause / Step
Cause / Step