Table of Contents
Advertisement
Connecting to the Tx/Rx socket
LiPo with JR connector
!
WARNING: Never connect your batteries as shown in the images below, as this may
damage the battery or charger.
Fire or explosion hazard!
JR connector polarity
incorrect!
Using the charger for the first time
Connect the charger's 100 ~ 240 VAC input to a mains wall socket or the charger's DC input to a car
battery or power supply unit with a capacity of at least 10 A with 11 to 15 VDC.
!
WARNING: Never connect the two inputs at the same time. The power must only
ever be supplied by one input.
The charger beeps twice and the status LED flashes green approx. every four seconds.
The QUICK LiPo 15 is ready for operation. Connect the battery to start the charging process.
The slide switch can be used to alter the charging current.
_
+
Balancer connector
the wrong way round!
INNOVATION & TECHNOLOGY
NOTE: The black battery con-
nection cable (-) must always
be on the right-hand side.
_
With BEC connector
_
+
XH - PQ - TP
Incorrect balancer
connector!
13
Advertisement
Table of Contents
