Main Data Labels For Load Calculation; Main Data Labels For Injection - Bosch MS 6 Manual

4 | Prepare Data Base
4.1.6
4.1.7
32 / 78

Main Data Labels for Load Calculation

Main Data Labels for Load Calculation
CWLOAD
CWLOADP1
alpha/n system
FRLPAMB_P1
FRLTINT
MP_RL
p/n systems
FRLPAMB_P1
FRLPTINT
FRLPTHR
MP_RLP1 ... P4
PALTCOR
MP_RL
Notice: For details please refer to the Function Description LOADCALC.

Main Data Labels for Injection

Main Data Labels for injection
CWHPI
CWINJANGMODE
MP_AOINJ
ECU MS 6
Decision between alpha/n or p/n rela‐
ted load calculation
Decision between P1 and ambient pres‐
sure
Correction via intake air pressure
Correction via ambient temperature
Usually the predefined values are suita‐
ble. If unsure, set FRLTINT to 1.0 for first
startup.
Relative load depending on throttle an‐
gle and engine speed. Set value until
your desired Lambda is matched.
Correction via intake air pressure
Correction via ambient temperature.
Usually the predefined values are suita‐
ble. If unsure, set FRLPTINT to 1.0 for
first startup.
Factor to throttle dependence. If un‐
sure, set to 1.0 for startup.
Relative load depending on throttle po‐
sition 1‐4
Altitude correction for relative load. If
unsure, set PALTCOR to 0.0.
Relative load depending on throttle an‐
gle and engine speed. Set value until
your desired Lambda is matched.
Choice LP‐ or HP battery voltage cor‐
rection
Choice of angle of injection relation
Map begin/end of injection
Bosch Motorsport