Panasonic VDR VDR-D220 Operating Instructions Manual page 101

Problem
The DISC EJECT lever
does not work.
The disc cannot be read.
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
Recording does not start
although power is
supplied to this unit and
the disc or card is
correctly inserted.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
Recorded still pictures
are not clear.
≥ The disc cover will not open unless the unit is powered.
# Connect a charged battery or AC adaptor.
≥ The DISC EJECT lever does not work when the unit is
connected to the computer. (l 104)
≥ Are there fingerprints or dirt on the surface of the disc?
# If there are fingerprints or dirt on the disc, wipe them off. (l 24)
≥ If you set [SETUP]>[DISPLAY]>[OFF], indications other than
warnings and date indications disappear.
≥ Is the DVD-RAM or the DVD-RW (VR format) write-protected?
# Release the protection. (l 75) If the DVD-RAM or DVD-RW (VR
format) was protected on another device, release the protection
on the same device.
≥ Has the DVD-RW (Video format) or DVD-R been finalized?
# After finalizing, the discs become play-only and cannot record. If
you un-finalize a DVD-RW (Video format), it can be used for
recording. (l 75)
≥ Has the SD card's write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set to
LOCK. (l 23)
≥ Is the memory of the disc or card full?
# If the disc or card has no more available memory, free up some
memory by deleting unnecessary scenes (l 64, 71) or use a
new disc or card.
≥ Is the unit set to the video recording mode or picture recording
mode?
# No recording is possible unless the mode dial is at
≥ Is the disc cover open?
# If the cover is open, this unit may not operate normally. Close the
disc cover.
≥ Is the disc scratched or dirty?
# Clean the disc. (l 24) If there are scratches on the disc, use a
new disc.
≥ The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a while.
≥ Are you trying to record small or finely detailed objects with
[PICT.QUALITY] set at [
# If you try to record small or finely detailed objects with
[PICT.QUALITY] set at [
mosaic-like pattern. Record with [PICT.QUALITY] set at [
instead. (l 47)
Check points
]?
], the images may break up into a
Others
or .
]
101
LSQT1146