Light Bulb Replacement - Hotpoint CTA13 Use And Care Manual

Light bulb
replacement
A light bulb and socket are
located at the top of the fresh food
compartment. A flexible shield
surrounds the lamp to help prevent
accidental breakage.
Light shield–
press both sides
To replace the light bulb, unplug
the refrigerator's power cord plug
from the wall outlet. Press the sides
of the light shield, near the front,
release the locking tabs and
Unscrew burned-out bulb and
replace it with a standard W-watt
appliance bulb. Then push light
shield up and press sides until tabs
lock into slots above.
When you goon
vacation
For extended vacations or absences,
shut off power to refrigerator,
turn the numbered control to "O'.
position, and clean interior with
baking soda solution of one
tablespoon of soda to one quart
of water. Wipe dry. To prevent
odors, leave open box of soda in
refrigerator. Leave doors open.
For shorter vacations, remove per-
ishable foods and leave controls at
regular settings. However, if room
temperature is expected to drop
below W°F. follow same instruc-
tions as for extended vacations.
11
When you move
Disconnect power cord from wall
outlet and remove all food. Follow
defrosting instructions (see page 9),
then clean and dry the interior.
Sponge out defrost water pan (see
page 10) to prevent spillage.
Secure dl loose items such as
shelves, storage pan and ice trays
by taping them securely in place
to prevent damage.
Be sure refrigerator stays in
during actual moving
position only
and in van. Refrigerato~ must be
secured in van to prevent move-
ment. Protect outside of refrig-
erator with blanket.
.
upright