Panasonic Palmcorder Multicam PV-DV73 Operating Instructions Manual page 45

4, 5
To listen to the desired audio sound, set
the 12bit AUDIO setting of the VCR mode
MENU (Menu OSD: p. 108) as follows:
12bit AUDIO:The following selections are
available for 12 bit AUDIO dubbed
recordings only (sound recorded in SP
mode only).
Set this position to listen to the
ST 1
original sound.
Set this position to listen to the
ST 2
audio dubbed sound.
Set this position to listen to both
the original sound and the audio
MIX
dubbed sound.
Note
• When a 16 bit recording is dubbed over,
the original audio of the recording will be
erased.
• When a 12 bit recording is dubbed over
and played back, and MIX is selected as
the AUDIO, both the original audio and
the dubbed audio are played back.
• If you recorded in LP mode, you cannot
use the A.DUB feature.
Memory-Stop Editing
You can set an automatic Dubbing stop
point.
D
RESET
A
MENU
PAUSE
Editing Features
4
Press (PAUSE) to start Audio
Dubbing. "A.DUB
appears.
• Connect the Palmcorder to the TV in
order to monitor the sound.
(p. 38)
Only NTSC (National Television Standards
Committee) recorded tapes can be audio
dubbed. The following screen appears if
the tape was not recorded in NTSC format.
5
Press (PAUSE) to stop Audio
Dubbing.
• If the microphone used for dubbing gets
too near the speaker of your TV,
a howling noise (feedback) may occur.
• If the tape position is in or was started in
a blank section, you cannot use the
A.DUB feature.
A
Press MENU to display the VCR
FUNCTIONS menu screen.
B
Rotate JOG KEY to select
SETUP , and then press JOG KEY
to display the DISPLAY SETUP menu.
C
Rotate JOG KEY to select
C. DISPLAY , and then press JOG
KEY to set to MEMORY.
D
Press MENU to exit MENU mode.
Then, press RESET on the remote
control to reset the Counter Memory
to M 0:00.00.
Now, rewind to the editing start point,
and continue with steps 2-5. The tape will
now stop automatically at "M 0:00.00".
" indication
DISPLAY
45