Replacing Restraint System Parts After A Crash - Chevrolet Corvette Owner's Manual

Replacing Restraint System Parts
After a Crash
CAUTION:
{
A crash can damage the restraint systems
in your vehicle. A damaged restraint
system may not properly protect the
person using it, resulting in serious injury
or even death in a crash. To help make
sure your restraint systems are working
properly after a crash, have them
inspected and any necessary
replacements made as soon as possible.
If you have had a crash, do you need new belts or
LATCH system (if equipped) parts?
After a very minor collision, nothing may be
necessary. But if the belts were stretched, as they
would be if worn during a more severe crash,
then you need new parts.
If your vehicle has the LATCH system and it was
being used during a more severe crash, you
may need new LATCH system parts.
If belts are cut or damaged, replace them.
Collision damage also may mean you will need to
have LATCH system (if equipped), safety belt
or seat parts repaired or replaced. New parts and
repairs may be necessary even if the belt or
LATCH system (if equipped) was not being used
at the time of the collision.
If an airbag inflates, you will need to replace
airbag system parts. See the part on the airbag
system earlier in this section.
If the frontal airbags inflate, you will also need to
replace the driver's and right front passenger's
safety belt buckle assembly. Be sure to do
so. Then the new buckle assembly will be there to
help protect you in a collision.
After a crash you may need to replace the driver
and front passenger's safety belt buckle
assemblies, even if the frontal airbags have not
deployed. The driver and front passenger's safety
belt buckle assemblies contain the safety belt
pretensioners. Have your safety belt pretensioners
checked if your vehicle has been in a collision,
or if your airbag readiness light stays on after you
start your vehicle or while you are driving. See
Airbag Readiness Light on page 189.
I n f o r ma t i o n P r o v i d e d b y :
67