Chevrolet Corvette Owner's Manual page 246

If your vehicle has the Bose
®
includes Bose AudioPilot
technology. When turned on, AudioPilot
continuously adjusts the audio system to
compensate for background noise, so that the
music always sounds the same at the set volume
level. This feature is most effective at lower
radio volume settings where background noise
can affect how well you hear the music being
played. At higher volume settings, where the music
is much louder than the background noise, there
may be little or no adjustments by AudioPilot
®
To use AudioPilot , set the radio volume to your
desired level. Turn AudioPilot
the automatic volume button until AVOL ON
appears on the display. As the vehicle goes faster,
the background noise increases. AudioPilot
adjusts the audio system's sound level to
overcome background noise. To turn AudioPilot
off, press the automatic volume button until
AVOL OFF appears on the display. For additional
information on AudioPilot
MUTE: Press this button to silence the system.
Press this button again to turn the sound on.
This button is not available on the Radio
with Six-Disc CD.
246
®
audio system, it
®
noise compensation
®
®
.
®
on by pressing
®
®
®
, visit www.bose.com.
Finding a Station
BAND: Press this button to switch between FM1,
FM2, AM, or XM1 or XM2 (if equipped). The
display shows the selection.
O
/ (Tune): Turn this knob to select radio
e
stations.
t u
SEEK : Press the right or the left arrow to go
to the next or to the previous station and stay there.
The radio only seeks stations with a strong signal
that are in the selected band.
t u
SCAN : Press and hold either arrow for
two seconds until FREQUENCY SCAN appears on
the display. The radio goes to a station, plays
for a few seconds, then goes on to the next
station. Press either arrow again to stop scanning.
To scan preset stations, press and hold either arrow
for four seconds until PRESET SCAN appears on
the display. The radio goes to the next preset
station, plays for a few seconds, then goes to the
next preset station. Press either scan arrow again
or one of the pushbuttons to stop scanning presets.
The radio only scans stations with a strong signal
that are in the selected band.
I n f o r ma t i o n P r o v i d e d b y :