Troubleshooting - D-Link AirPremier N DAP- 2590 User Manual

DAP- 590 User's Manual
This chapter provides solutions to problems that can occur during the installation and operation of
the DAP-2590 Wireless Access Point. We will cover various aspects of the network setup, especially
the network adapters. Please read the following if you are having any technical difficulties.
Note: It is recommended that you use an Ethernet connection to configure the DAP-2590.
1. The computer used to configure the DAP-2590 cannot access the Configuration menu.
 Check if the LAN LED on the DAP-2590 is ON. If the LED is not ON, check if the cable for
the Ethernet connection is securely inserted.
 Check if the Ethernet adapter is working properly. Please see item 3 of this Troubleshooting
section to check that the drivers for the network adapters are loaded properly.
 Check if the IP address is in the same range and subnet as the DAP-2590.
Note: The default IP address of the DAP-2590 is 192.168.0.50. All the computers on the network
must have a unique IP address in the same range, e.g. 192.168.0.x. Any computers that have
identical IP addresses will not be visible on the network. They must all have the same subnet
mask, e.g. 255.255.255.0.
 Do a Ping test to make sure that the DAP-2590 is responding. Go to Start>Run>Type
Command>Type ping 192.168.0.50. A successful ping will show four replies.
Note: If you have changed the default IP address, make sure to ping the correct IP address
assigned to the DAP-2590.
D-Link AirPremier N Dual Band PoE Access Point

Troubleshooting

Troubleshooting
69