ProForm SpaceSaver 700 PFIVEL74313.0 User Manual page 6

STEP 1
Fasten front stabilizer (35) with 2 carriage bolts
(36) from the underside of stabilizer. Secure with 2
curved washers (13), 2 cap nuts (40). Fasten Rear
stabilizer (101) with 2 allen bolts (100).
Remove the Front main frame welding(33),keep
the entire main frame horizontally.
Using Bolt (95) into the busing ,to keep the main
frame assemble tightly.
Attention: Before insert the bolt,Pls to adjust the
Knob under the bottom tube to keep it in Horizontal
In this way make the bolt inserted smoothly
STEP 2
Carefully lift the Handlebar Post (26) until it is verti-
cal.Connect the Upper Computer Cable (31) and
the Connecting Wire (32).
Remove the loosely fitted Allen bolts (15),spring
(14) and curved washers (13) from the Main Frame
and the Handlebar Post (26) into position. Loosely
re-fit the 2x M8 Allen Bolt (15), 2 Spring (14) and
2 Curved Washers (13),M8 Allen Bolt(30),M8 Nut
(22) and align the Handlebar Post so it is straight
then tighten the Allen bolts fully.
101
100
30
6
13
35
40
36
95
26
31
32
22
14
15
13