Suggested Next Steps; Troubleshooting - Cisco WAP361 Quick Start Manual

Follow the Setup Wizard instructions to finish the WAP device
S 7
TEP
installation.
We strongly recommend that you use the Setup Wizard for the first
installation. For more advanced configurations, see the
Administration Guide. A link to the Administration Guide is found in
"Where to Go From
Congratulations, you can now start using the Cisco WAP361.

Suggested Next Steps

7
In case of an error while installing, try the troubleshooting procedures
described in this section.

Troubleshooting

If you cannot display the web-based Configuration Utility, you can test the
ability of the computer to communicate with the Cisco WAP361 by using
ping.
To use ping on a computer running Windows:
Verify that the Cisco WAP361 is powered on and the lights if they
S 1
TEP
do not indicate the appropriate links.
Locate the Cisco WAP361's IP address. While there are different
S 2
TEP
ways to locate the IP address, this procedure uses Cisco FindIT.
a. If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see www.cisco.com/go/findit.
b. In the Cisco FindIT display, place your mouse over the device's
name. The Cisco WAP361's IP address is displayed along with
other device information.
Open a command window by choosing Start > Run and enter
S 3
TEP
cmd.
At the command window prompt, enter ping and the Cisco
S 4
TEP
WAP361's IP address. In this example, we pinged 192.0.2.10.
If successful, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
Cisco WAP361 Quick Start Guide
Here".
11