Multimedia integration kit for select audi and volkswagen vehicles in sat emulation (40 pages)
Summary of Contents for Audiovox 50-0301x-002 SERIES
Page 1
Check for wiring or other componentry behind VCP area before installing. Materials/ Tools required for this installation: 1. #2 Phillips screwdriver 3. Awl or similar tool 5. Audiovox VCP (AVP-7180 or equiv.) INSTALLATION INSTRUCTION # 44-0040A INSTALLATION INSTRUCTIONS 50-0301x-002 SERIES 1181334 50-0301x-014 SERIES 1181332...
Page 2
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, # 8X 9/16" PWH SCREW, # 8 X 3/4" PPH VCP MOUNTING BRACKET VCP HOUSING FOAM TAPE, 3/4" X 3/4" X 14" INSTALLATION INSTRUCTION # 44-0040A Nov. 8, 1999 Printed in the U.S.A.
Page 3
I. PREPARATION OF VEHICLE INTERIOR FIGURE 1 3. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar.
Page 4
5. Remove and discard (2) two screws from the left side of VCP. See Figure 4. FIGURE 5 9. Place VCP housing (item 4 pg 2) over VCP. Lightly mark the location where housing mates to side panel. Remove VCP housing. FIGURE 4 6.
Page 5
FIGURE 7 12. Install VCP housing (item 4 pg 2) and secure to mounting bracket using (2) two # 8 X 9/16" screws, removed in step 4. (item 1 pg 2). See Fig. 8. Make sure Velcro tape adheres to bottom of VCP housing. FIGURE 9 10.