Panasonic EW3153 Instructions Manual page 20

Taking a Reading
Measurement
The entire display
will light for approx.
1 second.
The pressure cuff
will be tightened
automatically.
The heart mark
will blink when pulse
is detected during
pressurization.
19
English
(continued)
1 Press the On/Off and Start button on the main
unit.
(1) After the entire display on the wireless display
has been lit, the pressure cuff will be tightened
automatically.
() Pressurization will be performed automatically
and measurements will be taken.
* It may take about 1 second for the wireless display
to turn on after pressing the On/Off and the Start
button. This is not abnormal.
* The angle of the main unit may change slightly
while pressurizing. This will not affect accuracy.
2 When measurement has been completed, the
blood pressure and pulse values will be
displayed.
The cuff will loosen after the measurement
result has been shown for about 5 seconds.
• The blood pressure indication ( mark) will flash
for 6 seconds then stay lit. If the measurement is
high, it will also flash for 6 seconds to indicate high
blood pressure. (See page .)
• The mark will light. (For storing measurement
values, see page 4.)
• The pulse rate value is the beats per minute
calculated based on the pulse rate during
measurement.
• The mark is displayed when pulse rate could not
be measured.
3 Remove your arm from the main unit.
4 To switch off the blood pressure monitor, press
the On/Off and Start button on the main unit.
• If you forget to switch it off, the blood pressure
monitor will switch off automatically after
approximately  minutes.
• When the Adjust button "" on the wireless display
is pressed, indications disappears but the power
of the main unit is still on for about  minutes.