Daikin Altherma ERHQ006-008AD Technical Data Manual page 126

2 Specifications
2-4 ELECTRICAL SPECIFICATIONS
Power supply Voltage range
hydraulic
component
Wiring connections Connection type
3
2
Notes
126
• Monobloc • EDLQ011-016AA6V3
EDLQ011AA6V3
Minimum V
Maximum V
Quantity of wires
Type of wires
Connection type
Quantity of wires
Type of wires
Type of wires
Connection type
Quantity of wires
Type of wires
Connection type
Quantity of wires
Type of wires
Type of wires
Connection type
Quantity of wires
Type of wires
Type of wires
Connection type
Quantity of wires
Type of wires
Type of wires
Power supply compressor compartment is for compressor, fan, pump and controller
In accordance with EN/IEC 61000-3-11 (1), it may be necessary to consult the distribution network
operator to ensure that the equipment is connected only to a supply with Zsys (3) smaller than or equal
Power supply hydraulic compartment is for the electric heater. The optional domestic warm water tank
Installer can reduce capacity of the heater from 6 to 3kW. The current is then reduced from 26 to 13A.
Installer can reduce capacity of the heater from 6 to 3.5kW. The current is then reduced from 8.7 to
(1)European/International Technical Standard setting the limits for voltage changes , voltage
fluctuations and flicker in public low-voltage supply systems for equipment with rated current <= 75A.
(2) European/International Technical Standard setting the limits for harmonic currents produced by
equipment connected to public low-voltage systems with input current > 16A =< 75A per phase.
TM
• Altherma • Monobloc
EDLQ014AA6V3
-10%
+10%
for power supply hydraulic compartment
2G
Select diameter and type according to national and local regulations
for power supply connection to optional sanitary tank + Q2L
3G
Select diameter and type according to national and local regulations
For more details on voltage range and current refer to installation manual
for connection with R5T
Wire included in option EKHWS*
Wire included in option EKHWS*
for connection with A3P
Depends on thermostat type, refer to installation manual
Select diameter and type according to national and local regulations
Voltage 230V / Maximum current: 100mA / Minimum 0.75mm²
for connection with M2S
3G
Select diameter and type according to national and local regulations
Voltage 230V / Maximum current: 100mA / Minimum 0.75mm²
for connection with M3S
3G or 4G
Select diameter and type according to national and local regulations
Voltage 230V / Maximum current: 100mA / Minimum 0.75mm²
to Zmax.
has a separate power supply.
Instructions see installation manual.
5A. Instructions see installation manual.
(3) System impedance
Conditions: Ta DB/WB 7°C/6°C - LWC 35°C (DT = 5°C)
EDLQ016AA6V3