Saeco HD8763 Operating Instructions Manual page 80

ENGLISH
78
Machine actions
The machine grinds coff ee
beans but no coff ee comes out.
(see note)
Coff ee is too weak.
(see note)
Coff ee is brewed slowly.
(see note)
Coff ee leaks out of the dispens-
ing spout.
Frothed milk is too cold.
The milk is not frothed.
The milk does not come out.
The machine is in demo mode.
Causes
There is no water.
The brew group is dirty.
The circuit is not primed.
This might occur when the machine
is automatically adjusting the dose.
The dispensing spout is dirty.
This might occur when the machine
is automatically adjusting the dose.
The coff ee grind is too fi ne.
The circuit is not primed.
The brew group is dirty.
The dispensing spout is clogged.
The cups are cold.
The milk carafe is dirty or not
inserted correctly.
The milk carafe dispenser has not
been removed correctly.
The milk carafe is not fully
assembled.
The type of milk used is not suitable
for frothing.
The button was pressed and
held for more than 8 seconds.
Note:
* These problems can be considered normal if the coff ee blend has been
changed or if the machine has just been installed. In this case wait until the
machine performs a self-adjusting operation as described in the "Saeco
Adapting System" chapter.
Solutions
Fill the water tank and prime the circuit
(see the "Using the Machine for the
First Time" chapter).
Clean the brew group (see the "Weekly
Cleaning of the Brew Group" chapter).
Prime the circuit (see the "Using the
Machine for the First Time" chapter).
Brew a few cups of coff ee as described
in the "Saeco Adapting System" chapter.
Clean the dispensing spout.
Brew a few cups of coff ee as described
in the "Saeco Adapting System" chapter.
Change coff ee blend or adjust grind-
ing as explained in the "Adjusting the
Ceramic Coff ee Grinder" chapter.
Prime the circuit (see the "Using the
Machine for the First Time" chapter).
Clean the brew group (see the "Weekly
Cleaning of the Brew Group" chapter).
Clean the dispensing spout and its
holes.
Preheat the cups with hot water.
Clean the carafe and insert it correctly.
Check that the milk dispensing spout
has been removed correctly.
Make sure that all components have
been correctly assembled.
Use the type of milk suggested in the
"Milk Carafe" chapter.
Disconnect the power cord and turn
the machine back on.