Dubbing To A Video Unit Equipped With A Dv; Connector (Digital Dubbing) - JVC GR-DA20EK Instructions Manual

Dubbing To A Video Unit
Equipped With A DV

Connector (Digital Dubbing)

It is also possible to copy recorded scenes from
the camcorder onto another video unit equipped
with a DV connector. Since a digital signal is sent,
there is little, if any, image or sound deterioration.
Core filter
Video unit equipped with DV connector
To use this camcorder as a player
1 1
1 1
Make sure all units are turned off.
2 2
Connect this camcorder to a video unit
2 2
equipped with a DV input connector using a
DV cable as shown in the illustration.
3 3
3 3 Start playback on the camcorder (
4 4
4 4
At the point you want to start dubbing, start
recording on the video unit. (Refer to the
video unit's instruction manual.)
5 5
5 5 To stop dubbing, stop recording on the
video unit, then stop playback on this
camcorder.
To DV OUT
DV cable (optional)
To DV IN
18).
Notes:
●
It is recommended to use the AC Adapter as
the power supply instead of the battery
pack. ( 13)
●
If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not
dubbed.
●
Even though the DV cable is connected
correctly, sometimes the image may not appear
in step . If this occurs, turn off the power
4 4
4 4
and make connections again.
●
When using a DV cable, be sure to use the
optional JVC VC-VDV204U or VC-VDV206U
DV cable.
31
Editing
EN