Turn And Lane-Change Signals - Chevrolet 2006 Avalanche Owner's Manual

Turn and Lane-Change Signals

The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
To signal a lane change, raise or lower the lever for
less than one second until the arrow starts to flash. This
will cause the turn signals to automatically flash three
times. It will flash six times if the tow-haul mode is
active. Holding the turn signal lever for more than one
second will cause the turn signals to flash until you
release the lever. The lever will return by itself when it
is released.
3-8
As you signal a turn or a lane change, if the arrows
flash more quickly than normal, a signal bulb may
be burned out and other drivers will not see your turn
signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows do not go on at all when you
signal a turn, check for burned-out bulbs and a blown
fuse. See Instrument Panel Fuse Block on page 5-114
and Underhood Fuse Block on page 5-117.
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.