Adjust Sweep Hose To Fit Pool Depth; Adjust Float Hose To Fit Pool Length - Polaris 65 TURBO TURTLE User Manual

2

Adjust Sweep Hose to Fit Pool Depth

1. Measure the deepest part of the pool.
Add two feet to this measurement to
determine the correct length for the
sweep hose.
2. If the sweep hose is longer than
the measured amount, cut off the
excess hose.
3. Remove the hose connector from the
excess hose piece just cut.
4. Use fingers to collapse sweep hose.
Push hose into connector until the first
groove is inside.
5. Slide fingers inside hose, through
connector, and pop hose back to
original shape.

Adjust Float Hose to Fit Pool Length

3
With float hose attached to the pool wall at the return line, extend the hose to the farthest
point of the pool. The end of the hose should be 4 feet shorter than this point.
Hose too long? Cut the excess float hose. Remove the hose connector from the excess
hose piece and attach it to the new end of the float hose as instructed above.
Hose too short? For Polaris 165/Super Turtle only, add the float hose extension between
the existing float hose section and the surface module. Remeasure and adjust as necessary.
1. Open the frame of filter bag completely and attach it to jet sweep assembly. Attach
assembly to sweep hose.
2. Attach float hose and sweep hose to the surface module.
3. Put the Polaris in the pool and turn on the pool filtration pump.
4. Extend the float hose to the farthest point in the pool. When the pool pump is running, the
surface module should be approximately one foot from the pool wall.
Hose
Connector
Return line
www.polarispool.com
Collapse Here
Insert
to Here
feet