Bosch WFL 2060UC Training Program page 70

70
WFL 2060 Service Tips
WFL 2060 Service Tips
Measurements from Control Module (2)
Measurements from Control Module (2)
Disconnect & measure 2 connectors to measure heater.
between pin 1 (far left connector in group of 7 pins) and pin 2 (2nd pin from
right) of pressure switch connector. Heater should read 23.2 - 29.4 Ω.
WARNING! Unplug washer before making any resistance measurements.
Disconnect & measure white 6-pin connector
(with wires) to measure drum drive motor.
blue
Motor should read (pin 1 is at far right):
• Pins 1-2:
• Pins 3-4:
• Pins 5-6:
1
1
connector
with
14 - 35 Ω
1.5 - 10 Ω
0.7 - 2.1 Ω
1
1
Pink
pink
wires
Measure
-- Resistance
-- Resistance
Disconnect & measure white 3-
pin connector (with
to measure door latch motor.
Measure between pins 1-2 (pin 1
at far left). Motor should read ~
500 - 1500 Ω.
1
1 1
1
Black connector
with wire
pink
1st Edition/Revision 5 (1/20/04)
wires)
blue