Wfr 2460Uc Sales Demo Mode; Sales Demo Mode Procedure; Conversion; Power Hook-Up - Bosch WFL 2060UC Training Program

25
Operation
Operation
CAUTION:
To avoid danger of electrical
shock, make sure the washer is unplugged
before changing any electrical connections!

SALES DEMO MODE PROCEDURE:

disconnecting the drain pump. To set up WFR2460 washers for display:

Conversion:

Make sure the washer is unplugged and is not connected to any water lines.
1. Remove the three shipping bolts from the washer back panel, removing the top bolt last. Each bolt has an insert wedging up to
the inside of the back panel. When removing bolts, loosen them, then move them (up, left or right) until they slide out the large
circular holes (matching the insert sizes). Don't unscrew shipping bolts completely so inserts won't drop into the washer base.
After removing bolts, cover the holes with white caps included with the washer.
2. To access the white (or gray)
T-30 Torx screws. Pull the
frame or any washer parts with electrical tape (to avoid possibility of electrical shock).
3. Replace the back panel, then attach the

Power hook-up:

Plug the washer into a 120V/240V transformer, then plug the transformer into a 120V, 15A power outlet.
Using demo mode:
Rotate the cycle selector knob to the "
spin cycle. To interrupt the spin cycle, push the "
HINT: Before starting, make sure you have
the following:
B
120V/240V transformer
Fuscia demo mode label ("IMPORTANT")
Access to 120V, 15A, 60Hz electrical outlet
T-20 & T-30 Torx screwdrivers
Electrical tape
NOTE: WFL2060
Do not connect
for sales demonstration -- all lights will turn
on and washers won't run.
--
--

WFR 2460UC Sales Demo Mode

WFR 2460UC Sales Demo Mode
IMPORTANT:
floors, replace the
and replace the shipping bolts so washers won't be damaged during shipment.
Preparing WFR2460 washers for display involves removing three shipping bolts and
drain pump connector from the back of the washer, remove the back panel by removing (7) T-20 & (4)
white (or gray) drain pump connector to remove it, then secure the loose connector away from the
fuscia label to the rear of the washer so its visible.
Start/Pause
Shipping bolt locations
washers
Suggested placement for
When reselling any WFL2060 or WFR2460 washers from display
white (or gray) drain pump connector so washers will run properly
Spin
" position and then push the "
" button.
IMPORTANT
label
fuscia
("IMPORTANT")
Start
" button to perform a complete
WFR2460 drain pump is
located at washer right
front corner
viewing rear of washer)
Pull off white (or
gray) drain pump
electrical connector
1st Edition/Revision 5 (1/20/04)
(photo