Panasonic KX-FP70CX Service Manual page 153

15.1.2.1. Maintenance List
No. OPERATION
1 Document Path
2 Rollers
3 Platen Roller
4 Thermal Head
5 Sensors
6 Glass
7 Abnormal, wear and tear
or loose parts
15.1.2.2. Maintenance Cycle
No. Item
1
Separation Roller (Ref. No. 145)*
2 Separation Rubber (Ref. No. 13)
3 Feed Rollers (Ref. No. 11, 56, 94)
4 Thermal Head (Ref. No. 40)
5 Platen Roller (Ref. No. 90)
6 Pickup Roller (Ref. No. 96)
Note:
1
* These values are standard and may vary depending on usage conditions.
2
* Refer to 20.1.Cabinet, Mechanical and Electrical Parts Location (P.195).
CHECK
Remove any foreign matter such as paper.
If the roller is dirty, clean it with a damp cloth then dry thor-
oughly.
If the platen is dirty, clean it with a damp cloth then dry
thoroughly. Remove the paper and film cartridge before
cleaning.
If the thermal head is dirty, clean the printing surface with a
cloth moistened with denatured alcohol (alcohol without
water), then dry thoroughly.
Document top sensor (SW337), Document set sensor
(SW338), Cover open sensor (SW502), Paper top sensor
(SW502), Film detection sensor (SW501), Film end sensor
(SW1003) . Confirm the operation of the sensors.
If the glass is dirty, clean them with a dry soft cloth.
Replace the part. Check if the screws are tight on all parts.
Cleaning Cycle
3 months
2
3 months
3 months
3 months
3 months
3 months
Cycle
(31,500 documents) Refer to 14.2.13.HOW TO REMOVE THE
1
7 years*
7 years (31,500 documents) Refer to 15.4.1.Document feeder/recording
7 years (31,500 documents) Refer to 14Disassembly and Assembly
7 years (31,500 documents) Refer to 14.2.6.HOW TO REMOVE THE THER-
7 years (31,500 documents) Refer to 14.2.7.HOW TO REMOVE THE
7 years (31,500 documents) Refer to 14.2.8.HOW TO REMOVE THE PICKUP
153
REMARKS
—
Refer to 15.4.1.Document feeder/recording
paper feeder/scanner glass cleaning (P.161).
—
Refer to 15.4.2.Thermal Head Cleaning (P.162).
See 15.1.2.Maintenance Check Items/Compo-
nent Locations (P.152) and 14.2.11.HOW TO
REMOVE THE DIGITAL, ANALOG, SENSOR
BOARDS (P.147).
Refer to 15.4.1.Document feeder/recording
paper feeder/scanner glass cleaning (P.161).
—
Replacement
Procedure
MOTOR BLOCK AND SEPARATION ROLLER
(P.149).
paper feeder/scanner glass cleaning (P.161).
Instructions (P.135).
MAL HEAD (P.142).
PLATEN ROLLER AND BACK COVER (P.143).
ROLLER (P.144).
KX-FP701CX/KX-FP702CX