Operator's Guide (BA)
3 Operation
3.15
Display window
Display
3.16
Program selection
Selection
BA/3-38
•
of the selected workpiece
•
of the selected global main program
•
of the selected global subprogram.
Fig. 3-30
Display window
•
of the current workpiece
•
of the current global main program
•
of the current global subroutine.
Program selection is possible only in the Reset state.
Fig. 3-31
Program selection
Selection of a workpiece/program becomes active if access rights,
machine state, etc. do not prevent it.
Otherwise, an error message is triggered.
In both cases, the currently selected program is displayed.
You can close the window by selecting the "OK" softkey.
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01