09.01
3.11.2
Unload tool
© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
1. Select the softkey "Unload".
An enquiry window requesting confirmation of the command to
unload the tool from the current location is displayed.
The tool data are not deleted from the TO area.
Fig. 3-21
Unload tool
2.
Select the softkey "Delete".
The tool is unloaded and the tool data are deleted from the TO
area.
The basic display is output again when the tool has been unloaded.
You can cancel the unloading process by selecting the "RECALL" key.
Notes
•
It is not possible to unload a tool from an empty location.
•
The softkey is activated only if there is a tool in the loading position.
Operator's Guide (BA)
3 Operation
BA/3-31