Hotpoint CTX22D How To Get The Best page 11

Drawers at the bottom of the fresh
food compartment will stop before
coming dl the way out of the
refrigerator, to help prevent contents
from spilling onto floor. These
drawers can be removed easily by
grasping the sides and lifting up
slightly while pulling drawers past
the "stop" location.
To remove drawem and X cover
when the f~h fd compartment
door cannot be opened fully:
and remove it.
3. Reach in, push the front of the
glass cover up and, at the same
time, pull it forward until it clears
the frame at the back.
4. Tilt and remove the glass cover.
slides.
5. Remove the 3 drawer
follows:
Lift the front of the frame to free
it from the supports at each side.
Lift the rear of the frame to free
its hooks from the tracks on the
back wall of the refrigerator.
. Tilt the frame and tike it out.
11
replace:
To
1. Fit the hooks on the drawer
frame into the second-from-the-
bottom slots on the tracks at the
rear of the refrigerator and lower
the front of the frame until it locks
into position and rests on the front
supports at each side.
2. Put the drawer slides back on
the frame. The sloped ends must
beat the front.
3. Slide the center and right drawer
slides toward the middle and slide
the l/3-width drawer all the way
into them.
4. Slide the l/3-width drawer all the
way to the right.
5. Mount the 2/3-width drawer
onto the center and left slides.
its rear edge firmly into the rear
frame channel and gently lowering
the front into place.