Setting Up Stylus Pro 10600 - Epson STYLUS PRO 10600 Assembly And Set-Up Manual

6. Hook the both ends of the center shafts on the
upper basket hooks.
7. Hold the front side shafts and turn it one
revolution as shown below.
8. Slide out the lower basket hooks to their full
length, then attach the L shape ends to the joint
sockets on the front side.
9. Hook the paper feed support film (G) on the
intermediate shaft of the paper basket, so that
it hangs along the inner surface of the basket.
10. Set 10 paper feed support films (G) at even
intervals of approximately 4 inches.
11. Slide the upper and lower basket hooks back.
12. Hook the basket rings in the directions shown
below to take up the slack.

Setting up Stylus Pro 10600

Connecting the power cord
1. Connect the power cord (R) to the AC inlet on
the back of the printer.
5