Table of Contents
Advertisement
*6:
Select "Off" to avoid entering standby mode when there is no input signal.
*7:
Does not function when "Type A USB", "Type B USB" or "Network" is selected as the input.
In this case, it becomes equivalent to "Standard."
*8:
Reflecting changes in WLAN settings may take a few moments.
*9:
To set the IP address manually, select "Manual", press "Apply", then enter the IP address.
*10: When you send images or files from a tablet PC/smartphone and display them (page 66), set
"WLAN Network" to "Access Pt." to use the IFU-WLM3 USB wireless LAN module (not
supplied) as a wireless access point.
*11: To change the settings for "Access Pt.," go to the Web page.
For details, see "Setting the WLAN Network of the projector" (page 40).
If "Access Pt." is set, it is more convenient that you set "Display Setting" in "Network
Presentation" of the projector to "AP Mode" (page 30) in advance when you use Presentation
Function via the network (page 59).
*12: For changing the settings for "Client," use the Web browser for change. For details, see
"Setting the WLAN Network of the projector" (page 40).
*13: Constant Brightness mode will be enabled for about 2,000 hours after it is activated at early
usage. After this period, it will be disabled automatically. Activated time and brightness may
vary depending on the usage conditions.
*14: If the projector cannot connect wirelessly, click [Apply] once again to make sure the
connection is established. For details, see "Setting the WLAN Network of the projector"
(page 40).
*15: This mode does not function while "Interactive Mode" is set to "PC Free" (VPL-SW636C
only). In this case, "Lamp Mode" becomes equivalent to "Standard" (page 35).
*16: This mode does not function while "Interactive Mode" is set to "PC Free" (VPL-SW636C
only). In this case, "With No Input" will be "Off " (page 35).
*17: This mode does not function while "Interactive Mode" is set to "PC Free" (VPL-SW636C
only). In this case, "With Static Signal" will be "Off " (page 35).
*18: If the image output settings of the HDMI device are not appropriate, the bright parts in the
image may become too bright, or the dark ones may become too dark.
*19: Do not turn off the projector soon after the lamp lights. It may cause a malfunction of the lamp
(does not light ,etc.).
32
The Connection/Power Menu
Hide quick links:
Advertisement
Table of Contents
