Epson EB-G7905U User Manual page 145

List of Functions
Submenu
to Disabled, the projector goes into standby status in
approximately 75 seconds after power off.
• Inv Direction Button: Set this to On when the projector
is installed on a ceiling.
• HDMI DDC Buffer: If the image from a device
connected using an HDMI extension cable is not
displayed correctly, turning this On may improve the
image.
• DVI-D DDC Buffer: If the image from a device
connected using a DVI extension cable is not displayed
correctly, turning this On may improve the image.
• Lens Type: When using the following lens, select the
model number of the lens.
ELPLS04, ELPLU02, ELPLR04, ELPLW04, ELPLM06,
ELPLM07, ELPLL07
Date & Time: Make system time settings for the projector.
s "Setting the Time"
Lens Calibration: Acquires the information of the lens
installed on the projector.
Function
p.43
Submenu
A/V Settings A/V Output: Set this to Always On if you want to output
audio and images to an external device even when the
projector is in standby status.
Monitor Out: Select the image source output to an external
monitor when the projector is in standby status. When set
to Auto, analog RGB signals from the Computer port or the
BNC port are output depending on which source was
selected when the projector was turned off.
Audio Settings: Perform the following audio related
settings.
• Audio Output: Select the audio to be output when
projecting images from the Computer port, BNC port, or
DVI-D port. When set to Auto, audio is output from the
audio port corresponding to each image input port.
s "Connecting Equipment"
• HDMI Audio Output: Select the audio source when
projecting images from the HDMI port. If you select
HDMI, audio for the image is output as it is. If you select
Audio3, audio is output from the Audio3 port.
If you set Communication On, you can perform the
Standby Mode
following operations even if the projector is in standby
mode.
• Monitor and control the projector over a network.
• Output audio and images to an external device. (Only
when A/V Output is set to Always On.)
• Communication from the HDBaseT port is enabled. (Only
when Control Communications is set to On.)
a
When monitoring or controlling the pro‐
jector using wireless LAN, set Connection
Mode to Advanced.
s Network - Wireless LAN - Connection
Mode
145
Function
p.46
p.149