Equipment - Echo SHC-225S Operator's Manual

SHC-225/S

Equipment

Use only ECHO attachments. Serious injury may result from the
use of a non-approved attachment combination. ECHO, INC. will
not be responsible for the failure of cutting devices, attachments or
accessories which have not been tested and approved by ECHO.
Read and comply with all safety instructions listed in this manual
and safety manual.
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace
as needed.
• Check that the cutting attachment is firmly attached and in safe operating
condition. Dull, loose or damaged blades should not be used.
Moving parts can amputate fingers or cause severe injuries. Keep
hands, clothing and loose objects away from all openings.
ALWAYS stop engine, disconnect spark plug, and make sure
◆
all moving parts have come to a complete stop before
removing obstructions, clearing debris, or servicing unit.
DO NOT start or operate unit unless all guards and protective
◆
covers are properly assembled to unit.
NEVER reach into any opening while the engine is running.
◆
Moving parts may not be visible through openings.
Periodically Check fuel system (fuel lines, vent, grommet, fuel tank,
and fuel cap) for leaks especially if the unit is dropped. If damage
or leaks are found, do not use unit, otherwise serious personal
injury or property damage may occur. Have unit repaired by an
authorized servicing dealer before using.
X7502257007
© 4/2016 ECHO Inc.
SAFETY
11