Assembling The Mulcher Plugs - Husqvarna LB448S Operator's Manual

Assembly
The blade must be mounted with the angled ends pointing
up towards the cover.
• Place the cutter with the friction washer against the
cutter bracket.
• Make sure the cutter centres correctly on the shaft.
• Fit the washer and tighten the bolt correctly. The bolt
should be tightened with a torque of 80 Nm.
ASSEMBLY
IMPORTANT!
Always exercise care and use your common sense.
Avoid all situations which you consider to be beyond
your capability. If you still feel uncertain about operating
procedures after reading these instructions, you should
consult an expert before continuing. Contact an
authorised service workshop.
Always use genuine parts. For more information, see
the "Technical data" section.

Assembling the mulcher plugs

• Disconnect the HT lead from the spark plug.
• Position the cutter with the spark plug upwards when
servicing the machine.
• Fit the leader pins into the holes on the cutting cover.
• Fasten the mulcher plugs from the top of the cutting
cover.
–
English 9