Table of Contents
Advertisement
Available languages
Available languages
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for
the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet
that is properly installed and grounded.Consult a
qualified electrician or serviceman if the grounding
instructions are not completely understood, or if
doubt exists as to whether the appliance is properly
grounded.
WARNING
Improper use of
the grounding plug
can result in a risk of
electric shock.
Do not use an
extension cord. If the
power supply cord
is too short, have a
qualified electrician
or serviceman install
an outlet near the
appliance.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 14
amps and 1.60 kilowatts. This product must be
connected to a supply circuit of the proper voltage
and frequency. Wire size must conform to the
requirements of the National Electrical Code or the
prevailing local code for this kilowatt rating. The
power supply cord and plug should be brought to
a separate 15 to 20 ampere branch circuit single
grounded outlet. The outlet box should be located
in the cabinet above the oven. The outlet box and
supply circuit should be installed by a qualified
electrician and conform to the National Electrical
Code or the prevailing local code.
Installation Instructions
Permanent and Correct Installation
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
TOOLS YOU WILL NEED
❒ 2 Phillips Screwdrivers (#1 & #2)
❒ Pencil
❒ Level
CUTOUT DIMENSIONS
Dimension
27"
Height
19
Width
26
Min. depth with receptacle outside cutout – 16"
Min. depth with receptacle inside cutout – 18"
120 volt – 60 Hertz grounded power receptacle.
1" Overlap
27"models: 1
30"models: 3
1" Clearance beyond
trim frame
(on all sides)
Bottom of trim kit must be
minimum of 36" from floor
WARNING
This trim kit uses air flow from the top, bottom and
sides of the trim frame. Blocking the air flow can cause
the microwave to function improperly and may cause
damage to the microwave.
Allow a 1" clearance beyond the edge of the trim
frame to provide proper air flow.
FOR INSTALLATION ABOVE A BUILT-IN OVEN:
Microwave oven should be installed on a 3/8" plywood
base and supported by 2x4 or 1x2 equivalent runners
on all sides. Base must be capable of supporting a
minimum of 100 lbs.
2
❒ Drill with 3/32" Drill Bit
❒ Tape Measure
Trim Kit
Cutout
30"
/
"
19
/
"
17
/
1
1
1
8
8
/
"
29
/
"
23
/
7
3
1
8
4
/
" overlap
7
8
/
" overlap
5
16
Height
Width
1" Overlap
±
/
"
1
16
16
±
/
"
1
8
16
Depth
3" Min.
Advertisement
Table of Contents
