GE JX9152 Installation Instructions Manual page 4

3 INSTALL THE REAR DUCT (continues)
6. Use three short screws to secure back of rear duct to the
back of microwave oven, as shown.
A
A. Short screws (3)
B. Rear duct
C. Back of microwave oven
4 INSTALL THE MICROWAVE OVEN
Plug the power cord into the wall receptacle. Slide the
microwave oven assembly gently into the cabinet, using
care not to pinch the power cord. Be sure to keep the
assembly centered as it slides back to where the tongue of
the rails goes through the slots on Base Plan. The top edges
of the Base Plan should now be centered right to left in the
opening. The Base should be tight against the cabinet.
Rail
Guides
Rails
5 CHECK LEVELING
Check the leveling by placing a level at the front and sides
of the microwave. It may be necessary to add wood shims
under the base pan to level the microwave front-to-back
and side-to-side.
DE68-03364A
49-40762
11-15 GE
Printed in China
Installation Instructions
B C
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
6 SECURE THE RAILS TO THE CABINET
Ensure the Base Pan and Bottom Bracket front flanges are
tight against the cabinet, and that the screws holes are
aligned. Drive 4 screws (A) through the Base Pan and Rails
into the cabinet
Mounting Holes
7 INSTALL THE TRIM KIT FRAME
1. Position the assembled Trim Kit frame around the
oven.
2. Drill pilot holes using the drill (3/22).
3. Secure the Trim Kit by four screws (B) through the trim
kit into the cabinet by using a manual screw driver.
IMPORTANT-
Start all screws before tightening any one screw. Do
not overtighten screws since it can cause misalignment of
top/side strips.
8 REPLACE ANY LOOSE ITEMS
1. Your trim kit is now fully installed. Replace the
turntable and turntable support that was removed
from inside the microwave oven.
2. Keep these installation instructions and extra screws
for future reference and need. Do not place them in
the microwave oven.
3. Replace the house fuse, or close the circuit breaker to
restore power at the service panel.
4
Screw A
Screw B