Location And Functions Of Parts And Controls; Camera; Usb Connector - Sony SRG-360SHE Operating Instructions Manual

Location and Functions
of Parts and Controls

Camera

Front
2 3
a Lens
This is a 30-magnification optical zoom lens.
b Infrared remote commander sensors
These are sensors for the supplied infrared remote
commander.
c POWER lamp
The green light turns on when the camera is connected
to an AC outlet using the supplied AC power adaptor
and AC power cable, or when power is supplied via
the LAN connector with PoE+.
d NETWORK lamp
The green light will turn on when the preparation for
network connection is done and all movements are
available.
e TALLY lamp
The status of video shooting can be indicated by the
lamp.
1
4 2 5
Rear
6
qaqsqd qf qg qh qj
f BAUD RATE switch
Used to switch between 9,600bps and 38,400bps for
the RS-422 baud rate.
g MIC input
Input for commercially-available MIC or LINE to
connect an Audio device.
* Switch between MIC and LINE input, as indicated
on page 22.
h Infrared remote commander sensors
These are sensors for the supplied infrared remote
commander.
i VISCA RS-422 connector (RJ-45 8-pin)
To communicate via RS-422, use this connector.
For the connecting cables, see "RS-422 connection
with IP remote controller RM-IP10" (page 20).
j IR SELECT switch
Select the camera number when you operate multiple
cameras with the same infrared remote commander.
k SYSTEM SELECT switch
Used to set method to output image signal, which is
output via HDMI and SDI OUT video connector.
For details, see "Setting of the SYSTEM SELECT
switch" (page 9).
l USB connector
This is not available to use. It is for maintenance
purposes.
m HDMI OUT video connector
Outputs the image from the camera as an HDMI video
signal.
8
8
7 8 9 q;