Table of Contents
Advertisement
To remove the expansion-card cage, perform the following steps:
1. Examine any cables connected to expansion cards through the back-panel openings and disconnect any cables that will not reach to where
the cage must be placed upon removal from the chassis.
2. Locate the securing lever (see Figure 21). Rotate the lever upward until it stops in an upright position.
Figure 21. Expansion-Card Cage Removal
3. Slide the expansion-card cage out of the chassis.
4. Lift the expansion-card cage up and away from the chassis.
To replace the expansion-card cage, perform the following steps:
1. With the securing lever in the upright position, align the expansion-card cage tabs with the slots in the chassis opening for the expansion-
card cage (see Figure 21). Slide the expansion-card cage into place.
2. Rotate the securing lever downward, until it is flush with the top side of the chassis. Make sure that the riser board is fully seated in the RISER
connector on the system board (see Figure 22).
3. Reconnect any cables you removed in
Riser Board
The mini tower chassis has a PCI riser board (see Figure 22). The PCI riser board provides three PCI expansion-card slots.
Figure 22. PCI Riser Board
To remove a riser board, perform the following steps.
CAUTION: Use a wrist grounding strap as explained in
1
Securing lever
2
Tabs (2)
3
Slots (2)
step 1
of the previous procedure.
1 Auxiliary power indicator (AUX_LED)
2 PCI expansion slot 5 (PCI5)
3 Wake On LAN (WOL) connector
4 PCI expansion slot 1 (PCI1)
5 Auxiliary power connector
"Precautionary
Measures."
Advertisement
Table of Contents
