Table of Contents
Advertisement
2. Disconnect the DC power and data cables from the back of the drive.
3. Squeeze the retaining tabs that extend from each side of the drive bracket and slide the bracket out of the bay (see
4. Turn the drive assembly upside down and unscrew the four screws that secure the drive to the bracket (see
NOTE: For easier access inside the chassis, you may want to
To install a 5.25-inch drive, perform the
Figure 8. 5.25-Inch Drive Removal
Figure 9. Drive Bracket
Hard-Disk Drive Removal
1.
Remove the computer
cover.
2. Remove the drive bracket from the chassis.
If a hard-disk drive is already installed on the drive bracket, disconnect the DC power cable and EIDE cable from the drive.
3. Remove the screw securing the hard-disk drive bracket to the front wall of the chassis. Grasp the front part of the bracket that serves as a
handle, and rotate the bracket up toward the back of the computer until it disengages from the floor of the chassis (see Figure 10).
Figure 10. Removing the Hard-Disk Drive Bracket
rotate the power supply
5.25-inch drive removal
procedure in reverse.
out of the way temporarily.
1 Metal tabs (2)
1 Metal tabs (2)
2 Drive bracket
Figure
8).
Figure
9).
Advertisement
Table of Contents
