Tool Kit; Removing And Installing The Shroud And Covers - Yamaha Phazer PZ50Y Owner's Manual

ESU13001

Tool kit

The service information included in this man-
ual and the tools provided in the owner's tool
kit are intended to assist you in the perfor-
mance of preventive maintenance and minor
repairs. However, additional tools such as a
torque wrench may be necessary to perform
certain maintenance work correctly.
1. Tool kit
ECS00780
NOTICE
Before starting the engine, make sure that
the tool kit is securely fastened (PZ50 /
PZ50RT / PZ50GT / PZ50MT) and that the
storage pouch zipper is completely
closed.
TIP
If you do not have a torque wrench available
during a service operation requiring one, take
your snowmobile to a Yamaha dealer to
check the torque settings and adjust them if
necessary.
ESU11763
Removing and installing the
shroud and covers
EWS00091
WARNING
Be sure shroud and covers are secured
before operation. A loose shroud or cover
could move and cause loss of control.
Periodic maintenance and adjustment
Shroud, front cover, and air filter case
cover
To open the shroud and remove the front cov-
er and air filter case cover
1. Unhook the latch, and then slide the front
cover upward
PZ50GT / PZ50MT).
Unhook the shroud latches, and then
slowly raise the shroud forward until it
stops (PZ50VT).
2. Loosen the fasteners, lift up the air filter
case cover slightly, and then unhook the
cover from the air filter case to remove it.
PZ50 / PZ50RT / PZ50GT / PZ50MT
1. Latch
2. Front cover
3. Air filter case cover
4. Fastener
PZ50VT
1. Shroud latch
2. Shroud
(PZ50 / PZ50RT /
49