Yamaha Phazer PZ50Y Owner's Manual page 35

Compression damping setting:
Minimum (soft):
12 click(s) in direction (b)*
Standard:
7 click(s) in direction (b)*
Maximum (hard):
2 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
Rebound damping force
The rebound damping force of each shock
absorber can be adjusted by turning its re-
bound damping force adjusting knob.
To increase the rebound damping force, turn
the adjusting knob in direction (a). To de-
crease the rebound damping force, turn the
adjusting knob in direction (b).
1. Rebound damping force adjusting knob
Rebound damping setting:
Minimum (soft):
20 click(s) in direction (b)*
Standard:
12 click(s) in direction (b)*
Maximum (hard):
3 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
Control functions
TIP
The damping forces will not decrease past the
minimum levels even if the adjusting knobs
are turned out more than the minimum set-
tings.
ESU10936
Adjusting the spring preload of the
center shock absorber and the rear
torsion springs
The spring preload can be adjusted by turning
the adjusting ring
PZ50MT / PZ50VT)
(PZ50RT) on the center shock absorber and
the adjusters on the rear torsion springs. Ad-
just the spring preload as follows.
Center shock absorber (PZ50 / PZ50GT /
PZ50MT / PZ50VT)
PZ50 / PZ50GT / PZ50VT
(b)
(a)
1. Spring preload adjusting ring
PZ50MT
(b)
(a)
1. Spring preload adjusting ring
(PZ50 / PZ50GT /
or adjusting nut
29