Initialization; The Satellite Page - Garmin GPSMAP 60CS Owner's Manual

GPSmap 60CS
Getting Started
Initialization & the Satellite Page
The GPSmap 60CS locates satellites above its position
The Heading
Bug indicates
your direction
of movement.
Satellite Page Acquiring Satellite Signals
4
Starting Up the GPS Receiver
When you turn on the GPSmap 60CS, the GPS receiver begins to search
for satellites in order to determine (fix) its location. This process is called
"initialization" and can take from 5 to 15 minutes the first time you use
your unit. Thereafter, if you haven't moved more than 600 miles from your
original location, it takes only seconds to minutes. In order to receive satel-
lite signals, you must be outdoors and have a clear view of the sky. Satellite
signals cannot pass through solid materials (except glass) or dense overhead
tree cover. To shorten the time required for this first initialization, select
"New Location" from the options menu, then you can use the Panning
Arrow on the Map Page to determine your general location so the GPSmap
60CS can search for just those satellites above your position.
To initialize your GPSmap 60CS:
1. Press and release the POWER key to turn on the unit.
2. Observe the "Power On" Page followed by the Satellite Page.
3. While the GPS receiver is searching for the satellite signals, a
"Locating Satellites" message followed by an "Acquiring Satel-
Options
lites" appears, until enough satellites signals are acquired to fix
Menu
its location. If the unit cannot get a satellite fix, a list of solutions
display. Highlight the most applicable and press ENTER.
You will also see a sky view array of the satellites overhead with your
GPS Elevation
position centered in the array. The outer circle represents the horizon and
display
the inner circle a position 45
indicate the number assigned to each satellite. A bar graph at the bottom
of the page displays the strength of signals from each satellite.
o from the horizon. The numbers displayed