Table of Contents
Advertisement
Levers
Power LED
Fault LEDs
AC power switches
AC power connectors
Strain-relief clamp
Removing a hot-swap power supply
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
To remove a hot-swap power supply, perform the following steps:
1. Turn off the ac power switch. See Figure 60 on page 81.
80
IBM TotalStorage FAStT100 Storage Server: Installation, User's, and Maintenance Guide
Use these locking handles to remove or install a power supply.
These green LEDs light when the storage server is turned on and receiving
ac power.
These amber LEDs light if a power supply failure occurs or if the power
supply is turned off.
Use these switches to turn the power supplies on and off. You must turn on
both switches to take advantage of the redundant power supplies.
This connection is for the ac power cord.
Use this clamp to provide strain relief on the power cord.
Advertisement
Table of Contents
