Removing The Modem; Installing The Modem - Dell Inspiron 510m Service Manual

Back to Contents Page
Modem
Dell™ Inspiron™ 510m Service Manual

Removing the Modem

CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1. Follow the instructions in "Preparing to Work Inside the
2. Remove the keyboard.
3. Disconnect the display cable from the display cable connector on the system board.
4. Remove the M2 x 3-mm screw.
1 modem cable 4 pull-tab
2 modem 5 modem connector on system board
3 M2 x 3-mm screw
5. Pull up on the pull-tab to disconnect the modem from the modem connector on the system board.
NOTICE: Do not disconnect the modem cable from the system board.
6. Disconnect the modem cable from the modem.

Installing the Modem

1. Connect the modem cable to the modem.
2. Slip the left end of the modem and the modem cable underneath the metal modem-securing clip.
NOTICE: Ensure that the modem cable is routed correctly when you replace the modem.
3. Ensure that the modem cable is properly routed under its routing clip.
NOTICE: Do not press down on the left side of the modem while installing it.
4. Align the connector on the bottom of the modem with the modem connector on the system board and then press down on the right side of the modem
to seat both connectors.
Computer."