Behringer AMP800 Quick Start Manual page 5

8
MINIAMP AMP800
MINIAMP AMP800 Controls
(1) (2) (3) (4) (5) (6)
(9)
(7)
(10) (11) (12) (13)
9
Quick Start Guide
Controls
(EN)
(8)
LEVEL control: To adjust the input POWER connector.
(1) (9)
level of a signal, turn this control
PHONES OUT connectors: For each
(10)
toward 0 (minimum level) or,
Headphone Channel (1, 2, 3, and
alternatively 6 (maximum level).
4), the rear panel includes an
BALANCE control: To adjust the additional headphone connector,
(2)
stereo image of a signal, turn which is a stereo, ¼" TRS connector.
this control toward L (left) or,
LINK OUT A connectors: If you
(11)
alternatively R (right).
need more than the 4 Headphone
A + B meter: To monitor the Channels that a single AMP800
(3)
combined level of both signals provides, connect these balanced,
(A and B), use this meter. An ¼" TRS connectors (Left and Right)
LED glows next to the value that to the inputs of another AMP800.
identifies the combined level The LINK OUT A connectors
(-24 dB to 0 dB). If the signal is too send only the signal of Input
strong, the CLIP LED glows. Most of Channel A, without any LEVEL or
the time, the optimal level is 0 dB BALANCE settings.
(a full signal).
INPUT connectors: For each
(12)
(headphone) connector:
Input Channel (A and B), the rear
(4)
To connect a headphone, use this panel includes 2 balanced, ¼" TRS
stereo, ¼" TRS connector. connectors (Left and Right).
INPUT button: To select an Input SERIAL NUMBER.
(5) (13)
Channel, push this button.
PHONES LEVEL control: To
(6)
adjust the level of a headphone
Check Out behringer.com for
signal, turn this control toward
Full Manual
0 (minimum volume) or,
alternatively 6 (maximum volume).
CH meter: To monitor the level of
(7)
a headphone signal, use this meter.
An LED glows next tothe value that
identifies the headphone volume
(-24 dB to 0 dB). If the signal is too
strong, the CLIP LED glows. Most of
the time, the optimal volume is
0 dB (a full signal).
(power) button: To
(8)
turn the AMP800 on and off,
push this button.