Restoring From Service Position - Husqvarna P520 D Operator's Manual

5 Start the engine and lower the cutting unit to the lowest
position (floating mode). The cutting unit now hangs free
at the back.
6 Turn off the motor.
7 Remove the service strut from the cutting unit.
If it is the first time the service strut is removed, remove
the safety strap from the strut and place it in the storage
compartment under the seat.
8 Fit the service strut to the attachment under the base
plate. The attachment is highlighted in red.
9 Fit the other end of the strut to the attachment on the
cutting unit. Remove the pin and slide the strut across the
shaft which is marked red.
10 Release the pin so that it locks over the shaft.
MAINTENANCE AND SERVICE
11 Start the engine and raise the cutting unit to the service
position.
12 Secure the cutting unit with the safety belt, which is stored
in the storage compartment under the seat.

Restoring from service position

1 Remove the safety belt and place it in the storage
compartment.
2 Start the engine and lower the cutting unit to the lowest
position (floating mode).
3 Remove the service strut and place it on the cutting unit.
4 Raise the cutting unit halfway.
– 31
English