Stihl HT 56 C Instruction Manual page 13

To reduce risk of burns, do not touch the
muffler and other parts while they are
hot. Keep the area around the muffler
clean. Remove excess lubricant and all
debris such as pine needles, branches
or leaves. Let the engine cool down
sitting on concrete, metal, bare ground
or solid wood (e.g. the trunk of a felled
tree) away from any combustible
substances.
WARNING
An improperly mounted or damaged
cylinder housing or a
damaged/deformed muffler shell may
interfere with the cooling process of the
muffler. To reduce the risk of fire or burn
injury, do not continue work with a
damaged or improperly mounted
cylinder housing or a
damaged/deformed muffler shell.
Your muffler is furnished with a spark
arresting screen designed to reduce the
risk of fire from the emission of hot
particles. Never operate your unit with a
missing or damaged spark arresting
screen. If your gas/oil mix ratio is correct
(i.e., not too rich), this screen will
normally stay clean as a result of the
heat from the muffler and need no
service or maintenance. If you
experience loss of performance and you
suspect a clogged screen, have your
muffler maintained by a STIHL servicing
dealer. Some state or federal laws or
regulations may require a properly
maintained spark arrestor for certain
uses. See the "Maintenance, Repair and
Storing" section of these Safety
Precautions. Remember that the risk of
a brush or forest fire is greater in hot or
dry conditions.
HT 56 C
Reactive Forces
WARNING
Reactive forces may occur any time the
chain is rotating.The force used to cut
wood can be reversed and work against
the operator. If the rotating chain is
suddenly stopped by contact with any
solid object such as a branch or is
pinched, the reactive forces may occur
instantly. These reactive forces may
result in loss of control, which, in turn,
may cause personal injury. An
understanding of the causes of these
reactive forces may help you avoid the
element of surprise and loss of control.
Because of the design of the pole
pruner, the reactive forces experienced
when working with it are generally not as
severe as those encountered with a
chain saw. Nevertheless, you should
always maintain a proper grip and good
footing to control the power tool when
you experience such forces.
The most common reactive forces are:
kickback,
–
pushback,
–
pull-in.
–
Kickback
Kickback may occur when the moving
saw chain near the upper quadrant of
the bar nose contacts a solid object or is
pinched.
The reaction of the cutting force of the
chain causes a rotational force on the
pole pruner in the direction opposite to
the chain movement. This may cause
the bar to move upward.
To Avoid Kickback
The best protection from kickback is to
avoid kickback situations:
1. Be aware of the location of the guide
bar nose at all times.
2. Never let the nose of the guide bar
contact any object. Do not cut limbs
with the nose of the guide bar. Be
especially careful near wire fences
and when cutting small, tough
limbs, which may easily catch the
chain.
3. Cut only one limb at a time.
A = Pull-in
Pull-in occurs when the chain on the
bottom of the bar is suddenly stopped
when it is pinched, caught or encounters
English
A
11