Remote Gain Operation; Amplifier Wiring; Power Connections For The Orion Cobalt Co500 . And Co800; Speaker Connections - Orion Cobalt CO800.1 Owner's Manual

Orion car audio amplifier owner's manual
Hide thumbs Also See for Cobalt CO800.1:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
loudspeaker owner's manual for assistance in choosing the proper crossover frequencies for
your system .
Low-Pass Crossover
The low-pass crossover is active with a 2nd order (2dB per octave) slope . The low-pass crossover
is continuously variable from 50Hz to 500Hz .
Remote Bass Operation
The remote bass port provides easy remote access to the internal bass gain structure of the
power amplifier . The bass gain is centered at 44Hz . The RGC-2 plugs into the amplifier via the
/8" mini jack plug . The RGC-2 can be installed in the front of the vehicle to control the ampli-
fier bass gain level . The RGC-2 can be used as a bass level control when used on an amplifier
dedicated to subwoofers .

AMPLIFIER WIRING

Power Connections for the Orion Cobalt CO500.1 and CO800.1
Orion Cobalt CO500 . Fuse Size: 2 x 20 AMP ATC / CO800 . Fuse Size: 2 x 30 AMP ATC
Power connections accept up to 4 AWG wire .
4 AWG power and ground wire recommended for optimal performance .
Connect 2V+ to the battery through fuse holder . This connection provides +2V main
power to the amplifier .
Power wire must be fused no more than 8" from battery .
Ground amplifier to a good chassis ground as close as possible to the amplifier .
Connect REM terminal to remote turn-on lead from source unit . This connection pro-
vides +2V power to turn-on the amplifier .
Add extra ground wire between the negative terminal of the battery and the chassis .
Speaker Wiring Diagram CO500.1/CO800.1
The Orion Cobalt CO500 . and CO800 . amplifiers offer two positive and two negative output
terminals for ease of connecting the speakers to the amplifier . Since these are mono amplifiers, the
speaker connectors are paralleled internally . Each amplifier is stable to 2Ω .
Figure 3
Figura 3
Abbildung 3
6
MASTER
PHASE 0º
-
-
+ +
4Ω or 8Ω
Single 2Ω speaker
-
-
+ +
2Ω or 4Ω
SLAVE
PHASE 180º
-
-
+ +
or
2 ea. of 4Ω speakers
-
-
+ +
4Ω or 8Ω
4Ω or 8Ω
© 2007 directed electronics—all rights reserved

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cobalt co500.1

Table of Contents