Depression On The Leading Edge Is Left; Margins Are Wide - Canon imagePROGRAF iPF6400SE User Manual

Depression on the leading edge is left

In the printer driver, No or Print Cut Guideline is specified in
Automatic Cutting.
In the Control Panel menu, Cutting Mode is set to Eject or
Manual.
Depression on the leading edge is left
Depression on the leading edge is left
Keeping a roll in the printer for a long time
without printing on it may leave a depres-
sion on the leading edge.

Margins are wide

Margins are wide
Rolls are advanced a specific amount before cutting
to prevent problems with cutting and paper ejection.
When Cutting Mode in the Control Panel menu was
set to Manual, you selected Do not perform in re-
sponse to the "Perform the detection of paper
leading edge?" message.
578
Cause
Cause
When printing quality is most important, we recommend setting TrimEdge Reload to
On or Automatic so that the paper edge is automatically cut before printing.
(See "Menu Structure.")
Cause
Specify Yes in Automatic Cutting in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Corrective Action
P.436
➔
Corrective Action
This operation is normal.
Set Cutting Mode to Manual again, and select Perform(recommend) when
the "Perform the detection of paper leading edge?" message is displayed.
Note that when you select Perform(recommend), if the paper is strongly
curled, the Printhead may rub against the leading edge of the paper when
the printing starts.
(See "Specifying the Cutting Method for Rolls.")
iPF6400SE
Corrective Action
P.350
➔
User's Guide