Yamaha TDM900 Owner's Manual page 23

Right
1
2
1. Engine stop switch " / "
2. Start switch " "
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
INSTRUMENT AND CONTROL FUNCTIONS
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
EAU12350
or when the throttle cable is stuck.
Start switch "
EAU12400
Push this switch to crank the engine
with the starter.
CAUTION:
See page 5-1 for starting instruc-
EAU12460
"
tions prior to starting the engine.
". When re-
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard light (simultaneous flashing of all
turn signal lights).
The hazard light is used in case of an
EAU12500
emergency or to warn other drivers
"
when your vehicle is stopped where it
might be a traffic hazard.
EAU12660
CAUTION:
/ "
Do not use the hazard light for an ex-
" before starting
tended length of time, otherwise the
" to
battery may discharge.
EAU12710
"
ECA10050
EAU12731
"
" posi-
3-9
2
ECA10060
3
4
5
6
7
8
9